<< Click to Display Table of Contents >> Navigation:  »No topics above this level« PC 1550

For complete instructions, click the above link for the pdf manual. Click Thumbnail for expanded keypad view.

ARMING/DISARMING:

Away ARMING

Check to see that the 'Ready' light is lit. Enter a 4-digit Access Code. The 'Armed' light will come on. Leave through an exit door.

Stay ARMING

Check to see that the 'Ready' light is lit. Enter a 4-digit Access Code. The 'Armed' light will come on. Do Not leave premises.

DISARMING

Enter your Access Code to disarm anytime the system is armed.

DISARMING ERROR

If your code is invalid, the system will not disarm and a 2 second error tone will sound. If this happens hit # key, and try again.

 

BYPASSING:

With the system disarmed.

1.Press * 1

2.Enter the 1-digit Zone Number(s) of the zone(s) to be bypassed (1-6).

3.To exit bypassing mode and return to the Ready state, press #.

 

 

RESETTING SMOKE DETECTORS:

Your installer will inform you if the * 7 command has been set up to reset smoke detectors on your system

To reset the smoke detectors to normal, first clear all products of combustion from the detectors. Reset

the detectors by entering * 7 on the keypad.

If the detectors are clear of smoke, they will return to normal. If the detectors still have smoke in them, the

alarm will sound again.

DOOR CHIME:

1.Enter * 6 then the Master Access Code.

2.Press 6. The keypad will beep 3 times.

3.Press # to exit

Repeating this procedure will turn off this feature

 

MEMORY LIGHT:

Lights to indicate that an alarm has occurred

1.Press * 3 to view which zones generated the alarm.

2.Press # to exit

The memory will be cleared when the panel is re-armed

TROUBLE CODES:

Press * 2 to enter trouble display. The 'Zone' lights will indicate the type of trouble condition

1.Low Battery

2.AC Fail

3.Blown Fuse (Bell or Aux fuses)

4.Failed Attempt To Communicate

5.Fire Loop Trouble

6.Loss of Time on System Clock

Press # to exit trouble display. The 'Trouble' light will stay on until the trouble is resolved.

Time & Date Programming

1.Press * 6 plus your Master Access Code to enter User Functions.

2.Press 1 to select Time & Date.

3.Enter the time in 24-hr. format (HH:MM)

4.Press # to exit programming.

PROGRAMMING ACCESS CODES

It is highly recommended that all requests for assistance with access codes be referred to the dealer!

ADDING OR CHANGING CODES

1.Press * 5 plus the (Master Access Code). The 'Memory', 'Bypass', and 'Trouble' lights will flash and the 'Zone' lights will show which codes have already been programmed. Up to 6 codes can be programmed.

2.Press any key (from 1 to 6) to indicate which one of the 6 codes is being programmed. That 'Zone' light will flash.

3.Enter the new 4-digit Access Code

4.Press # to exit.

ERASING A CODE

To Erase a code, follow the same procedure, except, at step 3, enter * * * * instead of a 4 digit number.