<< Click to Display Table of Contents >> Navigation:  Alarm Panels > Apex Panels

For complete instructions click the above links for the pdf manuals. Click thumbnail for expanded keypad view.

Arming/Disarming

Away Arming

Push the * or A key. The green AWAY LED will light and the system will say, 'Armed to away'. If any zone is open while attempting to arm the system the system will say 'Zones open' and will not arm.

HOME (STAY) Arming

Push the # or H key. The red HOME LED will light, and the system will say 'Armed to home'. If any zone is open while attempting to arm the system the system will say 'Zones open' and will not arm.

Disarming

Enter your Disarm Code. The system will say 'Control is disarmed'.

Bypassing

System must be disarmed

1.Enter your Code and immediately press the 9 key. You will hear 'Bypassed mode, enter zone number'.

2.Enter the 2 digit Zone Number of the zone you wish to bypass. You will hear, '(description of zone) bypassed (On or Off)'.

3.Press the * or A key. The yellow STATUS LED will light to indicate the zone is bypassed, or the LCD keypad will display the Zone Descriptor and beep.

•A second push of the * or A key within 10 seconds will remove the zone from bypass.

•Pressing 00 while in bypass mode will clear all bypasses.

4.Press the # or H key to exit Bypass Mode. You will hear, 'Exit'.

•If ten seconds pass without pressing any keys, the system will automatically exit Bypass Mode.

Resetting smoke detectors

•Whenever any wired smoke detector activates the system, they will latch 'ON' until you reset them.

•To reset the smoke detector, enter your Primary Code, followed by 6. The system will say, 'Smoke power'.

Status

•The STATUS LED will flash when there is new information.

•Pressing the STATUS key will cause the system to automatically speak system status.

•The STATUS LED will be on solid when the status has been asked for and spoken.

•The STATUS LED will be off when there is no new information.

Monitor (Chime)

Pressing the MONITOR key toggles the system between 3 possible monitor conditions:

•Monitor On - System will announce doors and windows when opened

•Monitor Off - System will not announce doors and windows when opened.

•Beep - System will beep when doors and windows are opened.

Setting the clock

Apex Advantage

1.Press the 2 and 8 keys simultaneously from a hard wired keypad. The system will say, 'Enter Four'.

2.Enter 4 digits for the Time, in a 24 hour format. The system will then confirm the entered time.

Apex Destiny

1.Press the 2 and 8 keys simultaneously from a hard wired keypad. The system will say, 'Enter four digit time'.

2.Enter the Time, in a 12 hour format. After entering the time, the system will say, 'enter (1) AM, (2) PM'.

3.Press the 1 or 2 key to select AM or PM. The system will then confirm the entered time.

User Code Programming

Adding/Changing User Codes

1.Enter your Primary Code, then press 7. The system will speak 'Enter user number'.

2.Enter 2 digit User Number (01-32 for Apex Advantage and Destiny 6100, 01-08 for Destiny 4100).

3.Enter the new 4 digit User Code. After the 4th digit is entered the system will say, 'Exit'.

Deleting User Codes

1.Enter your Primary Code, then press 7. The system will speak 'Enter user number'.

2.Enter 2 digit User Number (01-32 for Apex Advantage and Destiny 6100, 01-08 for Destiny 4100).

3.Press the A key. The system will say, 'Code out'.