<< Click to Display Table of Contents >> Navigation:  Alarm Panels > Ademco Panels > Touchscreen

Click the above link to view the pdf manual. Click the thumbnail for an expanded keypad view.

arming/disarming

How to arm the system

How to arm multiple partitions

How to disarm upon entry

how to disarm when already inside

how to disarm multiple partitions

displaying faults

The Display Faults function is used when you see a 'Not Ready Fault' message and want to determine where the fault is and what type of fault it is. To display faults do the following:

Zone bypassing

how to bypass a zone

how to clear zone bypasses

silencing and clearing a fire/carbon monoxide alarm

1.Silence, acknowledge, and clear the alarm by:

a. For Residential Systems: Press Touch here to Silence on the display to silence the alarm.

For Commercial Systems: Enter your User Code. This silences and acknowledges the alarm and disarming of the system (if armed).

b. For Residential Systems: Press the CLEAR icon followed by your code. This acknowledges the alarm and the disarming of the system (if armed).

For Commercial Systems: Press the CLEAR icon followed by your User Code. The system attempts to clear the alarm from memory. If NOT successful (i.e., smoke in the detector) the Security screen is displayed and the Display Faults icon displays a 'Not Ready Fault'.

c. Press the DISPLAY FAULTS icon on the Arming screen. The faulted fire/carbon monoxide zone is displayed.

d. Press the CLEAR icon and then enter your User Code. This clears the Fire Alarm/CO Alarm from the system.

2.If the keypad does not indicate a READY condition after the second sequence, press the DISPLAY FAULTS key on the Arming screen to display the zone(s) that are faulted. Be sure to check that smoke detectors/carbon monoxide detectors are not responding to smoke, heat, or gas producing objects in their vicinity. In this case, eliminate the source of heat, smoke or leak.

3.If this does not remedy the problem, there may still be smoke/gas in the detector. Clear it by fanning the detector for about 30 seconds.

4.When the problem has been corrected, clear the display by entering the DISPLAY FAULTS icon on the Arming screen, selecting the fire or carbon monoxide zone, pressing the CLEAR icon and then entering your User Code.

troubles

The Security screen displays an icon if a system trouble occurs. The following icons may be shown:

setting time and date

Programming user codes

adding a user

After adding a user to the first keypad, the same user can be added to a second keypad, if present. From the second keypad go to 'User Setup' and enter the same user name and same user code (refer to “How to Add a User” above). The second keypad will automatically update the user information. Press Save.

editing a user

deleting a user