<< Click to Display Table of Contents >> Navigation:  Alarm Panels > FBI > FBI XL3 / XL3LT / XL31 / XL31LT

For complete instructions, click the above links for the pdf manuals. Click Thumbnails for expanded keypad views.

ARMING/DISARMING

Away ARMING

Verify that the 'Ready' indicator light is on, or that the display reads 'SYSTEM READY' .

Enter a 4-digit User Code. The 'Armed' light will come on. LCD Keypads will display 'ON: AWAY'.

Stay ARMING

Verify that the 'Ready' indicator light is on, or that the display reads 'SYSTEM READY' .

Press the STAY button.

Enter a 4-digit User Code. The 'Armed' light will come on. LCD Keypads will display 'ON: STAY '.

DISARMING

Enter your 4-digit User Code to disarm anytime the system is armed.

BYPASSING

With the system disarmed.

1.Press BYPASS button.

2.Enter a valid User Code.

3.Enter the 2-digit Zone Number (01-12)

Alarm Memory / Status

•If alarms or other conditions such as system troubles have taken place since the initial system arming, they will appear on the display.

•The conditions that have occurred appear in the zone display section of the keypad.

•LED keypads will reflect current system status through the indicator lights as follows:

•Burglary alarms will be indicated with a Steady sound, while Fire alarms will generate a Pulsing sound.

•LCD keypads will show the alarm conditions with a display as follows:

•The display shows the zones in alarm. After entry of a 4-digit User Code, the display will appear as follows:

•To clear the display of the alarm or trouble conditions and silence the audible signal, enter the 4-digit User Code again.

DOOR CHIME

Press the # button then the 6 button to turn the chime On or Off.

Setting the Time

If the system clock needs to be reset, LED keypads will blink rapidly in succession every 30 seconds. LCD keypads will display a message.

1.Press the # button, then the 3 button.

2.Enter a valid User Code (User 1 or User 2 Code).

3.Enter 2 digits for the Hour and 2 digits for the Minutes (using 24 hour clock).

Note: The User Code is not required if so programmed by the installer.

PROGRAMMING User CODES

Adding/Changing User Codes

1.Press the CODE button

2.Enter the Master User Code (User 1 or User 2)

3.Enter the 2-digit User Number (01-30)

4.Enter the new 4-digit User Code

Note: If Ambush Code capability has been set up by your installer, then user # 30 will be used for the Ambush Code. If and Arming Only Code (Maid Code) has been defined by your installer, then user # 29 can only arm the system.

Deleting User Codes

1.Press the CODE button

2.Enter the Master User Code

3.Enter the 2-digit User Number to be erased (03-30)

4.Press the # key