<< Click to Display Table of Contents >> Navigation:  Alarm Panels > Napco > P400

For complete instructions, click the above link for the pdf manual. Click Thumbnail for expanded keypad view.

ARMING/DISARMING

Away ARMING

1.Check to see that the green 'Status' light is lit.

2.Enter the Arm/Disarm Code, and then press the ON/OFF key.

Note: If you make a mistake entering the code, press RESET key,  enter a correct code, and press the ON/OFF key.

Stay Arming (Interior Zone Bypass)

This feature must be enabled by the dealer. Bypasses zones designated as Interior Zones.

1.Check to see that the green 'Status' light is lit.

2.Enter your Arm/Disarm Code, and then press the ON/OFF button.

3.Before the exit delay expires, press the BYPASS button to bypass any interior zones. The zone light of any bypassed zones will flash slowly.

DISARMING

Enter your Arm/Disarm Code , then press the ON/OFF button to disarm. The red 'Armed' light will go out.

Note: If you make a mistake entering the code, press RESET button, enter a correct code, and press the ON/OFF button.

Arming the system with a trouble condition present

1.Press the FUNCTION button followed by the 4 button to view trouble.

2.Press the INTERIOR button to scroll through any additional troubles, or to exit Trouble View Mode when there are no more troubles to display.

3.Enter your Arm/Disarm Code, and then press the ON/OFF button.

BYPASSING

With the system disarmed.

1.Press BYPASS button.

2.Enter the Zone Number of the zone to be bypassed. The bypassed zone's number will flash slowly.

3.Arm the system.

Silencing Alarm / Alarm Memory

1.To silence the system, enter your Arm/Disarm Code, then press the ON/OFF button. The keypad sounder will silence but the zone in alarm will continue to flash

2.Press the RESET button to reset this alarm memory.

Reset Function

Press the RESET button to reset Fire Zone, clear mis-entered codes, reset alam memory, etc.

DOOR CHIME

Pressing the FUNCTION button followed by the 5 button will activate/deactivate the door chime.

TROUBLE CONDITIONS

PROGRAMMING ACCESS CODES

This system can contain a maximum of 4 user codes. User Code 1 is required to program other codes as follows:

Entering the User Program Mode

1.Press the FUNCTION button followed by the 8 button.

2.Enter the User 1 Code, then press the ON/OFF button.

The Armed, Status, and Trouble lights will flash and the keypad will beep 4 times. You are now in User Program Mode. Zones 1 through 4 will light to indicate any user codes currently programmed.

Programming / Reprogramming User Codes

1.After entering User Program Mode, press the User Number (1 - 4) to be programmed. The keypad will beep 2 times, and the corresponding zone light will flash to indicate the user number you are about to program.

2.Enter the new 4-digit User Code. The keypad will beep 4 times.

3.If there are more User Codes to program, return to step 1 above, otherwise, go to Exiting User Program Mode below.

Erasing a User Code

1.After entering User Program Mode, press the User Number (1 - 4) to be erased. The keypad will beep 2 times and the corresponding zone light will flash to indicate the user number you are about to erase.

2.Press the INSTANT button. The zone light will go out to indicate that the code has been erased.

3.If there are more User Codes to erase, return to step 1 above, otherwise, go to Exiting User Program Mode below.

Exiting User Program Mode

When you are done programming or erasing User Code, press the RESET button to exit User Program Mode.